Page 1 of 1
DT368 specs
Posted: Sat Feb 13, 2010 9:10 pm
by quotaholic
The WebDT368 / Atigo T came with the same horizontal 40 pin IDE internal flash the the DT366 came with. The CPU was a Transmeta Conroe clocked at 1GHZ. These units came with a variety of options. Most were preloaded with Windows XPe, some ran XP Pro.
Here is a link to a cut sheet:
http://dtri.sg1002.myweb.hinet.net/pdf/webdt368.pdf
Re: DT368 specs
Posted: Fri Feb 19, 2010 8:02 am
by howie368
Detailed hardware list:
CPU - Transmeta TM5800 1Ghz
Supported instruction sets - IA MMX, CMPXCHG8B, Conditional move instruction
CPUID features - Debugging extension, Fast system call, Longrun, Longrun Table interface, Page size extension, virtual mode extension
L1 Cache - 96kb Sync
L2 Cache - 512 Kb Sync
Motherboard - Transmeta micro ATX TM-Q302
CAS latency - 1T
RAS to CAS latency - 1T
RAS precharge - 1T
ALi M5229 PCI ide bus controller
ALi M1533 PCI-ISA Bridge
Texas Instruments PCI-1520 PCMCIA cardbus Controller
ALi M7101 Power management Controller
ALi M5237 PCI to USB open host Controller
NEC PCI to USB open host controller
Memory - 256mb (total) effectively less due to CMS reserved memory, set in bios
Read benchmark - 618mb/s pc133 equivalent
Write benchmark - 237mb/s pc133 equivalent
BIOS - Phoenix (10/29/04)
Video - Silicon Motion LynxEM+ SM712
4Mb memory
24bit max color depth
Audio - ALi M5451
Touchscreen - Penmount 9000 Serial
Wireless - Cisco Aircard 350