Page 1 of 1

XPe image

Posted: Wed Mar 03, 2010 7:40 pm
by tt300zrcr
I built my own XPe image but it seems that when i boot it off using UFDprep and usb2.0 stick with 2.0 enabled on it it loads the FBA but it seems to run it off my Stick rather than my flash 1gig drive

If i let it continue to do that i just get the infamous Blue screen

any suggestions i didnt make a backup of the orginal Load which kinda fault so now i am trying to get it going again and cant. anysuggestion would be great.

Re: XPe image

Posted: Fri Apr 09, 2010 1:10 am
by knarz
of course you have to copy the xpe image to your DOM (disk on module).
my suggestion is to boot winpe and copy your image to your dom. restart and boot from dom
be patient to set the dom active and boot prepared.
therefor you can use diskpart and bootsect.exe (all official and free tools microsoft)

Re: XPe image

Posted: Tue Apr 20, 2010 7:15 am
by howie368
I have a 512 flash I pulled from the DT i modded that has XPe with all the drivers except IR. I'd be happy to dd you a copy but be aware that it is password locked from the grocery warehouse in which it was used. Also it has some inventory control software that steals focus and covers the desktop. If you need a copy as an emergency backup just ask.

Howard Phillips

Re: XPe image

Posted: Thu Apr 29, 2010 7:09 pm
by joneal2
Howie368 I would appreciate a copy of your XPe image for the DT 368.