DT360 Etch A Sketch issues. Shake it causes reboot!

Specifications and discussions on hardware for the DT360
Post Reply
evilbob
Newbie
Newbie
Posts: 7
Joined: Wed Oct 14, 2009 12:01 pm

DT360 Etch A Sketch issues. Shake it causes reboot!

Post by evilbob »

Ok I am using the DT360 in a car and every time I go over a bump in the road or a set of train tracks the Dt360 shuts off. I cannot turn it back on till I unplug it and turn off the battery switch then turn the switch back on. I have tested this with internal and external battery's Fully charged, I tested with only the internal battery, I tested without any battery's just running on the DC to DC inverter.

Basically I have discovered a way to turn the Dt360 into an Etch A Sketch. If you shake it, it will shutdown.

Anyone else had this issue or know how to fix it? I have tried it with Linux and stock Windows CE.

Thanks in advance.
evilbob
Newbie
Newbie
Posts: 7
Joined: Wed Oct 14, 2009 12:01 pm

Re: DT360 Etch A Sketch issues. Shake it causes reboot!

Post by evilbob »

Fixed finally figured this one out, Remove the PC speaker!

My first attempt was to put a rubber spacer on the back of the WIFI card, This didn't fix my issue but it made me feel better :)
Post Reply