Hi all, first of all a big thanks to all of you for posting on this forum!
Without it, my 2 red dt360lx units, which I bought 2 years ago, would have likely ended up in the bin. Bought them to use as an interface to a KNX homeautomation (webbrowser based) but the performance was to slow to be really usefull (with the installed winCE image).
Reading that Linux was giving these units a decent performance I was thinking of doing that but as I'm a 'windows' man, I was a bit reluctant.
Now with the 2 images provided from quataholic and the detailed process on imaging the unit, I''ve taken the plunge and started with Linux....
Did get them to work more or less but with some hickups and hope someone could give me a hint in the right direction for those.
I used the directions in http://webdt.org/forum/viewtopic.php?f=3&t=1069
to install the WebDT360-Debian6-2011-06-13
Note for other noobs like me: do
use the mentioned version of Clonezilla, latest version did not work! Also I needed to use the 'safe graphics mode' to start clonezilla.
Unfortunately the wireless was not working for me (with original VIA mPCIe card) and as I read that the VIA wireless card is not the best performer, I got a mPCIe card from an old Dell I had laying around, it's an Intel 3945abg but cant see it as an network interface.
modprobe -l *3945* does seem to indicate the module iwl3945.ko is there.
Question is now how to get that going as a live interface and visible in the Wicd network manager?
I also tried the 366 image WebDT366-Debian6-2011-06-12
-16-img (see above topic). I do like the Lxde desktop
but the cursor was way off and inverted.
Did get that working also (again, this forum gave me the hint)
Under section inputdevice, identifier penmount added the below line (just before 'EndSection')
Option "SwapY" "1" # invert Y axis
Then saved file and exit.
To calibrate the touch screen, in console:
That will start the calibration screen.[/list]
After reboot, screen was working ok on the red Dt360LX too!